![]() ![]() I went with a new wheel from Acelith Design in Italy. To be honest the whole setup I have is dedicated to the F1 2020 (and earlier) game so I really can't comment on using it with other software.Īs with a lot of other wheels the nice thing abot the T300RS is the ability to swap out the round wheel, and late last year I did just that. ![]() They have proven to be real workhorses for me. Please help, I really do want my wheel working again! Could it also be a physical issue, perhaps with the wires or even a faulty wheel? It was working at one point, and things such as auto-calibration and connecting to PC are working, so I assume not but I'm really desperate to get to the bottom of this.For about the last 6 years I've been using Thrustmaster (yes I know) wheels, on a PS4.įirst the 150 and now the T300RS. I've already contacted Thrustmaster Support via email, but it has been 4 days so I'm trying my luck with reddit, as well as ISR forums. However, during the installation, after auto-calibrating, the same generic Thrustmaster FFB game controller showed up on control panel and device manager. It seems as if the driver install detected just a generic Thrustmaster FFB wheel due to the issue, and therefore didn't install the specific firmware or drivers for my T150, so I tried the Bootloader method, which detected the T150 Bulk drivers fine, and it allowed me to choose to install them. I'm definitely sure the mode is set to PS3, by the way. I'm quite frustrated by this, having already done multiple driver reinstalls. I then tried turning the wheel, where it became very resistant and automatically returned to centre after I let go. I could not find the T150 firmware when clicking on properties, rather it only showed the normal game controller settings. However, it was displayed as 'Thrustmaster FFB wheel' with a generic gamepad icon rather than the T150. After the restart, I went to the control panel to check for the wheel. It still calibrated properly so I didn't assume otherwise. My first course of action was to reinstall the drivers, which I did and restarted the PC without checking the wheel other than taking the USB out and back in as the installation instructed. I exited my race session in game and went to the control mapping, and it would not let me change anything, as it showed that button 13 was being continually pressed. All the buttons except for buttons 11 and 12 were illuminated, meaning they were on, whilst I was unable to get buttons 11 and 12 to illuminate in the firmware. Again though when I checked the firmware, i noticed that whilst the wheel and t3pa pedals were working, the buttons were off. I opened up the firmare and tried the effects and they were all working fine, so i assumed that it was the game. ![]() However after trying rFactor for a while and then going back to Automobilista, the FFB wasn't there anymore. I opened up Automobilista and the wheel and FFB were all perfectly fine, with all the buttons working. The firmware was fine, showing a different settings panel from the normal windows game controller settings. ![]() The control panel showed the wheel separate from the other devices and specifically as a T150, and the device manager also showed the wheel as a T150. After the restart to finish the driver install, everything was in order. The first time opening and setting everything up was fine, the drivers installed correctly with the wheel connecting and calibrating fine. I bought the Thrustmaster T150 PRO FFB, and had it working on my PC. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |